Operating Instructions; Using The Electrobrush; How To Use The Electrobrush; Connecting The Electrobrush - Miele SEB 236 Operating Instructions Manual

These operating instructions are for
Electrobrush models:
1. SEB 236 without a cable
2. SEB 234 L with cable including plugs
and cable clips
The illustrations referred to in the text
are shown at the end of the operating
instructions.
The Electrobrush is driven by its own
motor. Two of the four rollers are height
adjustable to allow you to vary the
distance between the Electrobrush and
the floor to suit the type of surface being
cleaned. The Electrobrush is particularly
suitable for intensive vacuuming of
carpets which are subject to hard wear
and is very effective at removing deep
seated dirt and preventing areas of
frequent use being trodden into a path.
The standard floorhead or one of the
Miele floorbrushes should be used for
cleaning hard floors, such as tiled or
parquet floors.
It is also important to observe the
flooring manufacturer's cleaning and
care instructions.
,
Please note that the Electrobrush
should not be used for vacuuming
deep-pile rugs and carpets or
valuable hand-knotted rugs and
carpets, e.g. Persian and oriental
rugs etc. There is a danger of the
threads being pulled out. If in doubt,
contact the carpet manufacturer/
retailer.
^ To achieve the best effect, pass the
Electrobrush slowly backwards and
forwards over the carpet or floor
covering.
For rugs and carpets with fringes,
always draw the Electrobrush from the
middle of the rug or carpet across the
fringe towards the floor.
Connect the Electrobrush to the
vacuum cleaner as shown in the
illustrations at the end of the operating
instructions.
Hand-held vacuum cleaner: see
illustration a
Cylinder vacuum cleaner: see
illustration b
Cylinder vacuum cleaner: see
illustrations c and d.
The long cable needs to be secured to
the suction tube and also to the suction
hose. There are nine cable clips for this
purpose.
– two for securing the cable to the
suction tube (already in position)
– seven for running the cable along the
suction hose (these can be adjusted)
^ Fit the clips to the suction hose
leaving approximately the same
distance between each clip.
G
11