Problem Solving Guide; Replacement Parts - Miele SAB 110 Accu Nova Operating Instructions Manual

Removing threads and hairs
(See diagrams a, b and c at the end
of these operating instructions).
^ Cut any threads or hairs that have
become entangled in the roller brush
with a pair of scissors. There is a
groove along the roller to help you.
Then run the vacuum cleaner to
vacuum up the bits.
For more obstinate tangles or
blockages inside the battery-operated
brush, the cover can be opened.
^ Loosen the two locking screws on the
underside of the brush with a small
coin, and take off the roller cover.
The roller brush can now be taken out
of its supports and cleaned. The
compartment interior can also be
cleaned.
When re-fitting the roller brush
please note the following
(see illustration d)
There are notches on the supports.
With a new roller brush:
Fit the supports so that the single
notch points towards the roller cover,
(see left hand illustration). The bristles
protrude approx. 2 mm. This is
important for the brushing effect. When
the bristles are slightly worn out:
^ Fit the supports so that two notches
point towards the roller cover, (see
right hand illustration).
^ Put the roller cover back on and
close it, (see illustration e).
^ Tighten the locking screws. If the
bristles are totally worn out, a
replacement roller brush can be
purchased through your Miele Dealer
or the Spare Parts Dept.

Problem solving guide

If the "Operation / Blockage" indicator
light is red the roller brush has become
blocked.
^ Switch off the vacuum cleaner and
the battery-operated brush
immediately.
^ Remove the blockage, and switch the
vacuum cleaner and the battery-
operated brush back on.

Replacement parts

,
Only ever use original Miele
replacement parts. This will ensure
optimum performance of the
appliance throughout its life.
If you require a new battery, only
purchase an original Miele battery
(type ACCU NOVA A).
Spare parts are available from your
Miele dealer or from the Miele Spare
Parts Department.
G
13