Miele CVA 4085 Operating And Installation Manual page 74

Problem solving guide
74
. . . the fault message 10 or 17 appears.
Water has not been taken in.
^ The water container has not been correctly positioned
inside the machine. Remove the water container and push
it back into position again, making sure it is positioned
correctly.
^ This error message also appears if the water container was
not correctly filled for descaling. Fill the water container up
to the k mark.
^ After you have remedied the problem, switch the machine
off and then back on again after a short while. Select the
process you want again.
If this fault message still continues to appear in the display,
repeat the steps described above. If, despite this, the fault
message still appears in the display, call the Miele Service
Department.
. . . fault message 94 appears in the display.
There is a problem with the water inlet for the plumbed in
water supply.
^ Check whether the inlet hose has become kinked or the
stopcock is not fully open.
If neither is the case and the fault message still appears in
the display, call the Miele Service Department.
. . . fault message 95 appears in the display.
^ Switch the machine off and close the stopcock.
^ Call the Miele Service Department.
. . . the seal on the connection between the coffee outlet
and the brew unit is damaged and is leaking.
^ Replace it with the extra seal supplied.
^ Check the machine door. Over time the door can come out
of alignment and damage the seal. Align the door using the
hinges (see "Installation: Adjusting the door hinges").