Installation - Hobs with enclosed hotplates
These hobs are classified in Germany
as "Y" class for heat protection. They
must be positioned so that there is ade-
quate ventilation. There may be a wall
at the rear, and wall or tall units at one
side. On the other side however no unit
or divider must stand higher than the
Because of the heat given off, there
must be a minimum distance as fol-
– 40 mm between the worktop
cut-out and adjacent furniture,
e. g. tall unit.
– 50 mm between the back wall
and the worktop cut-out.
* building-in height
Prepare the worktop cut-out as
shown in the illustrations below.
Loosen the screws
Set the hob unit
and centre it.
Turn the screws
Check that the hob unit
on to the worktop.
into the cut-out
to the right, until
are firmly attached to