Download Print this page

Advertisement

Before using for the first time

Setting the rinse aid dosage

The rinse aid dosage can be set from
approx. 0-6 ml. It is set to a
recommended setting of approx. 3 ml
at the factory.
If spots appear on crockery and
glassware:
^ Increase the rinse aid dosage.
If clouding or smearing appears on
crockery and glassware:
^ Decrease the rinse aid dosage.
^ Switch the dishwasher off using the
Off button o.
^ Press the programme selector button
in, and whilst holding it in switch
the dishwasher on using the On
button g.
Keep the programme selector button
pressed in for at least four seconds
until the lower right hand programme
indicator (Pre-wash) comes on.
If this does not happen, start the
procedure from the beginning again.
^ Press the Tab button three times.
The "3 in 1" indicator will flash briefly
three times at intervals.
20
p 3 will flash in the Display.
This means that the rinse aid dosage
has been set to 3 ml to the factory.
The dosage set will show in the Display
after the p.
^ Use the programme selector button
to select the rinse aid dosage you
want.
The dosage amount alters each time
you press the button.
The programmed rinse aid dosage is
now stored in memory.
^ Switch the dishwasher off using the
Off button o.

Advertisement

This manual also for:

G 2470

Comments to this Manuals

Symbols: 0
Latest comments: