Before using for the first time
Setting the rinse aid dosage
You can adjust the rinse aid dosage for
best results.
The rinse aid dosage can be set from
approx. 0-6 ml. It is set to a
recommended setting of approx. 3 ml
at the factory.
If spots appear on crockery and
glassware:
^ Increase the rinse aid dosage.
If clouding or smearing appears on
crockery and glassware:
^ Decrease the rinse aid dosage.
^ Switch the dishwasher off with the
On/Off button s.
^ Turn the programme selector to the
"12 o'clock" position.
^ Press the Start/Stop button in and
whilst holding it in switch the
dishwasher on using the On/Off
button s.
Keep the Start/Stop button pressed in
for at least four seconds until the
"Start/Stop" indicator light comes on.
If this does not happen, start the
procedure from the beginning again.
20
^ Turn the programme selector to the
"5 o'clock" position.
The "Wash/Rinse" programme
sequence indicator will flash briefly
three times at intervals.
This means that approx. 3 ml of rinse
aid will be used per programme
(factory default setting).
The number of times the "Wash/Rinse"
indicator flashes tells you the rinse aid
dosage which has been set (see chart).
Rinse aid
in ml
0
1
2
3
4
5
6
^ Use the Start/Stop button to select
the number of flashes which equates
to the rinse aid dosage you want.
Each press on the button moves you
up a level.
The programmed rinse aid dosage is
now stored in memory.
^ Switch the dishwasher off with the
On/Off button s.
Flashing
-
Once
Twice
Three times
Four times
Five times
Six times