Table of Contents
Advertisement
Installation
Positioning the appliance in
the housing unit
^ Push the appliance into the housing
unit as far as the vapour strip and
align it.
Ensure that the housing unit is
aligned at a right angle.
^ Open the drawer, and use the 2
screws supplied to secure the
appliance to the side walls of the
housing unit.
24
The appliance is supplied with three
metal trims which have an adhesive
underside.
These trims must be stuck on to the
drawer so that they seal any gaps
between the housing unit and the
appliance. Any air gap created acts as
additional insulation and helps prevent
heat-loss.
^ Carefully pull the protective foil off the
underside of each trim.
^ Then position the trim as shown in the
illustration so that they are flush with
the side walls and the back wall of
the housing unit and then stick them
to the plate warmer. If the unit does
not have a back wall you do not need
the third trim.
^ Build in the combination appliance in
accordance with its operating and
installation instructions.
Hide quick links:
Advertisement
Table of Contents
