Reinstalling Wildcat Graphics Drivers; Bios Requirement; Setup And The Network Controller Driver - Intergraph Zx1 Manual

2
Device Manager may display an error (!) for the VGA Controller on the following video
controllers. You may ignore this designation, as it does not affect their operation:
Intense3D Wildcat 4105, 4000, 3510, 3410, 3400
RealiZm II VX113, VX113A

Reinstalling Wildcat Graphics Drivers

If you reinstall Windows 2000 on a system with Intense3D Wildcat graphics, you must install the
driver software for the Wildcat graphics controller after completing Windows 2000 Setup.
To install Wildcat graphics driver software in Windows 2000:
1. Log on to Windows 2000 using an account that has administrative privileges.
2. Right click My Computer and go to Manage » Device Manager » Other Devices » Video
Controller » Driver » Update Driver.
3. When the Upgrade Device Driver Wizard displays, click Next.
4. Select Search for a suitable driver for my device (recommended), and then click Next.
5. Make sure the appropriate search location is selected, and that Disk 1 of the driver media is
loaded in the appropriate drive; then click OK.
6. Under Driver Files Search Results, click Next to start the installation.
7. Insert Disk 2 when prompted, and then click OK to continue with the installation.
8. Once the driver successfully installs, click Close.
CAUTION Windows 2000 recognizes the dual pipelines in a Wildcat 4110 or 4210 graphics
controller as two devices. Repeat Steps 2 through 7 to complete the installation for
the VGA-compatible video controller driver.
9. Restart the computer.

BIOS Requirement

BIOS version 1.30B or later is required for Windows 2000.
Windows NT

Setup and the Network Controller Driver

CAUTION When going through Windows NT Setup (for the first time or to reinstall Windows
NT), do not let Setup auto-detect and configure the system's network controller. If
you do, the system may fail to operate correctly.