Download Print this page
Honeywell TRADELINE HC18A Installation Instructions
Honeywell TRADELINE HC18A Installation Instructions

Honeywell TRADELINE HC18A Installation Instructions

Humidifier pad

Advertisement

Available languages

Available languages

Quick Links

APPLICATION
The HC18A, HC22A, and HC26A Humidifier Pads replace the
humidifier pad in the Honeywell Flow-Through Humidifiers or
Aprilaire® Humidifiers. The humidifier spreads water over the
humidifier pad, and when warm air blows over the water-
soaked area, vapor is generated. As the vapor circulates
through the house, the relative humidity rises.
INSTALLATION
CAUTION
Personal Injury or Equipment Hazard.
Can cause electrical shock or equipment damage.
Disconnect power supply before installing or servicing.
Turn off water supply.
IMPORTANT
Do not remove the powder from the new humidifier
pad. The powdery coating on the pad promotes
water dispersement.
1. Remove the humidifier cover. See Fig. 1.
2. Remove the humidifier pad assembly from the humidi-
fier by grasping the assembly and pulling it toward you.
3. Pry open the frame at the corners until the PerfectFlo™
water distribution tray lifts off.
4. Gently pinch the water nozzle catches inward until the
water nozzle can be lifted off the tray.
5. Slide the humidifier pad out of the frame.
RECYCLE NOTICE
This humidifier pad is recyclable. After removing the
pad from the humidifier, wash off the powder and
recycle the pad with the aluminum recyclables.
IMPORTANT
Be careful not to punch the frame to prevent leaking.
Home and Building Control Home and Building Control
Honeywell
Honeywell Limited-Honeywell Limitée
1985 Douglas Drive North
35 Dynamic Drive
Golden Valley, MN 55422
Scarborough, Ontario
M1V 4Z9
® U.S. Registered Trademark
Copyright © 2001 Honeywell
• All Rights Reserved
69-1576EF G.H. 9-01 •
www.honeywell.com/yourhome
HC18A, HC22A, HC26A
Humidifier Pad
6. Carefully scrape any mineral deposits from the tray and
frame. Be sure nothing is blocking the frame drain hole.
7. Reattach the water nozzle to the PerfectFlo™ water dis-
tribution tray.
8. Insert the new humidifier pad into the frame.
IMPORTANT
Be sure the black line on the top of the humidifier pad
is facing up.
9. Replace the water distribution tray. Be sure all four tabs
are in place.
10. Place the humidifier pad assembly in the humidifier
housing and press until the assembly is completely
sealed. Be careful not to pinch or kink the water feed
tube.
Fig. 1. Humidifier components.
11. Replace the humidifier cover.
12. Turn on the power and water supply.
13. To verify the humidifier operation, refer to the Owner's
Guide Checkout Procedure section.
INSTALLATION INSTRUCTIONS
WATER FEED NOZZLE
PerfectFlo" WATER DISTRIBUTION TRAY
HUMIDIFIER
HUMIDIFIER PAD
HOUSING
COVER
FRAME
Printed in U.S.A. on recycled
paper containing at least 10%
post-consumer paper fibers.
WATER
FEED
TUBE
M12371A
69- 1576EF

Advertisement

loading

Summary of Contents for Honeywell TRADELINE HC18A

  • Page 1 7. Reattach the water nozzle to the PerfectFlo™ water dis- The HC18A, HC22A, and HC26A Humidifier Pads replace the tribution tray. humidifier pad in the Honeywell Flow-Through Humidifiers or 8. Insert the new humidifier pad into the frame. Aprilaire® Humidifiers. The humidifier spreads water over the...
  • Page 2 Imprimé sur papier recyclé contenant au moins 10% de fibres Golden Valley, MN 55422 M1V 4Z9 de papier post-consommation. ® Marque de commerce déposée aux É.-U. Copyright © 2001 Honeywell Tous droits réservés 69- 1576EF 69-1576EF G.H. 9-01 • www.honeywell.com/yourhome...

This manual is also suitable for:

Tradeline hc22aTradeline hc26a