Advertisement
Quick Links
Introduction
The 2635A-PRINT 120 and 2635A-PRINT 230 Serial
Printers (hereafter referred to as "the Printer") are 80-
Column Dot-Matrix Serial Printers that can be
connected directly to the Fluke Hydra Series (2635A,
2625A, and 2620A models hereafter referred to as
"the Hydra") to provide printed hard-copy output
without the need for a computer or software. The
Printer is shown in Figure 1.
Bail Arm
Lever
Figure 1. 2635A-PRINT Printer
Shipping Contents
The Printer comes with the following items:
Instructions for Printer setup and use (this sheet)
Quick Start Guide
Platen knob
Ribbon cartridge
Paper separator
CD-ROM with User's Guide and print drivers
Fluke RS42 serial printer cable
2558806
PN
February 2006
Serial 80 Column Dot-Matrix Printers
Paper Separator
Paper
Lever
Power
Switch
Platen Knob
egv001.eps
©2006 Fluke Corporation. All rights reserved. Printed in U.S.A.
2635A-PRINT 120
2635A-PRINT 230
Installation
XWWarning
To avoid possible electric shock or
personal injury:
Verify that the line voltage marked
on the back of the printer matches
the local mains supply before
connection.
Check that the voltage listed on
the rating plate, located on the
back of the printer, matches the
local mains supply voltage before
applying power.
Some Printer parts have been removed for shipping.
Reassemble its detached parts, as follows (see
Figure 1 and the Quick Setup Guide for details):
1. Install the platen knob on the shaft on the right-
side of the Printer, lining up the slot in the knob
with the pin on the shaft.
2. Remove shipping tape from the Printer, and open
the top cover.
3. The print head is held to one side by a plastic
shipping retainer. Remove the retainer. Save the
retainer in case the Printer ever needs to be
shipped.
4. Center the print head by gently pushing it to the
center of the platen area.
5. Attach the ribbon cartridge to the print head by
setting the front-end in place and carefully
snapping the ribbon down between the print head
and platen.
6. Attach the paper separator by slipping the hooks
on its front into the two slots on the top of the
Printer.
Instruction Sheet
®
1
Advertisement
Related Manuals for Fluke 2635A-PRINT 120
Summary of Contents for Fluke 2635A-PRINT 120
- Page 1 Paper separator CD-ROM with User’s Guide and print drivers Fluke RS42 serial printer cable 2558806 February 2006 ©2006 Fluke Corporation. All rights reserved. Printed in U.S.A. Serial 80 Column Dot-Matrix Printers Installation To avoid possible electric shock or personal injury: Paper Separator Some Printer parts have been removed for shipping.
- Page 2 2. Connect the 9-pin connector end of the RS42 serial cable to the RS-232C serial connector on the rear panel of the Hydra. 3. Connect power cord to the rear of the Printer, and plug it into an appropriate power outlet. 4. Turn the Printer power on.
-
Page 3: Specifications
Operation Before starting Scan on the Hydra, ensure that the Printer is set up and paper is loaded. Also check that the Hydra is set to Autoprint mode as described above. Press the button on the front of the SELECT Printer if necessary to put it on-line. - Page 4 Anywhere in the world: +1-425-446-5500 LIMITED WARRANTY AND LIMITATION OF LIABILITY This Fluke product will be free from defects in material and workmanship for 90 days from the date of purchase. This warranty does not cover fuses, disposable batteries, or damage from accident, neglect, misuse, alteration, contamination, or abnormal conditions of operation or handling.