Advertisement
Windows 2000
1
Select [Start] → [Settings] → [Control Panel] → [Network
and Dial-Up Connections] → [Local Area Connection].
The "Local Area Connection Status" dialog box will be
displayed.
2
Click [Properties] on the [General] tab.
The "Local Area Connection Properties" dialog box will
be displayed.
3
Click [Internet Protocol (TCP/IP)] on the [General] tab,
then click [Properties].
The "Internet Protocol (TCP/IP) Properties" dialog box will
be displayed.
4
Click [Advanced...], then [Properties] on the [Options]
tab.
The "TCP/IP Filtering" dialog will be displayed.
5
Select "Permit All" for TCP Ports, then click [OK].
The display returns to the "Advanced TCP/IP Settings"
dialog. Click [OK] to return to the "Internet Protocol (TCP/
IP) Properties" dialog.
Set the computer's IP address so that it does not conflict with (i.e. is not a duplicate of) DME units with host
addresses in the 1 ~ 153 range.
Set the subnet mask to "255.255.255.0".
The default gateway does not need to be set if you will not be connecting to an external network. If you will be
connecting to an external network set the host address to 254.
Use TCP-IP filtering to enable all TCP ports.
When using Windows XP SP2, disable the Internet connection firewall.
n Set DME and SP2060 device group master/slave status and IP addresses via the DME64N/24N or SP2060 front panel. DME8i-C/
DME8o-C/DME4io-C units can be set from the DME Designer application. Refer to the appropriate owner's manuals for details.
6
Click [Use the following IP address] on the [General] tab.
7
Enter your computer's IP address into [IP address], the
Gateway's IP address into [Default gateway], and
"255.255.255.0" into [Subnet mask].
n When installing on the same subnet as the DME unit(s), set
the gateway's host address to 254.
8
Click [OK].
9
Restart your computer.
DME Designer Installation Guide
9
Advertisement
