Advertisement
To connect a DME and a computer via USB, it is necessary to install the YAMAHA USB-MIDI Driver to the computer.
The YAMAHA USB-MIDI Driver is software that enables to transmit MIDI signal between computer and DME via USB cables or
USB-MIDI interface.
Installation
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
Windows 2000
1
Start the computer and use the "Administrator" account
to log into Windows 2000.
2
Select [My Computer] → [Control Panel] → [System] →
[Hardware] → [Driver Signing] → [File Signature
Verification] and check the radio button to the left of
"Ignore – Install all files, regardless of file signature" and
click [OK].
3
Insert the included CD-ROM into the CD-ROM drive.
4
Make sure the POWER switch on the DME is set to OFF
and use the USB cable to connect the USB terminal of
the computer (or the USB hub) to the USB terminal of the
DME. When the DME is turned on, the computer
automatically displays the "Found New Hardware
Wizard." Click [Next].
5
Check the radio button to the left of "Search for the
suitable driver for your device. (Recommended)."
The window that appears enables you to select the
location for installing the driver.
6
Check the "CD-ROM drives" box and uncheck all other
items. Click [Next].
n The system may ask you to insert a Windows CD-ROM while
it checks for the driver. Specify the "USBdrv2k" folder in the
CD-ROM drive (for example, D:\ USBdrv2k_\) and continue
installation.
7
When the installation is complete, the system displays
"Completing the Found New Hardware Wizard."
Click [Finish].
n Some computers may take about ten seconds to show this
screen after installation is complete.
8
Restart the computer.
The driver has been installed.
YAMAHA USB-MIDI Driver
Windows XP
1
2
3
4
5
6
7
8
9
The driver has been installed.
Start the computer.
Select [Start] → [Control Panel].
If the control panel shows "Pick a category," click "Switch
to Classic View" in the upper left of the window. All control
panels and icons will be displayed.
Select [System] → [Hardware] → [Driver Signing] → [File
Signature Verification], and check the radio button to the
left of "Ignore – Install all files, regardless of file signature"
and click [OK].
Click [OK] to close the System Properties window, then
click the Close button ([X]) at the top right of the window
to close the Control Panel.
Insert the included CD-ROM into the CD-ROM drive.
Make sure the POWER switch on the DME is set to OFF
and use the USB cable to connect the USB terminal of
the computer (or the USB hub) to the USB terminal of the
DME. When the DME is turned on, the computer
automatically displays the "Found New Hardware
Wizard."
n Some computers may take a few minutes to show this
screen.
Check the radio button next to "Install the software
automatically (Recommended)" then click [Next].
The system starts installation.
When the installation is complete, the system displays
"Completing the Found New Hardware Wizard." Click
[Finish].
n Some computers may take about a few minutes to show this
screen after the installation is complete.
Restart the computer.
DME Designer Installation Guide
3
Advertisement
