Network; Printing - Xerox 2101 Getting Started Manual

Xerox 2101
2-2

Network

·
If your Novell network is configured to print a banner page
with multiple copies of a job, you will receive as many copies
of the banner page as copies of the job. If you have
specified stapling, the banner page is stapled to the job. To
print successfully, ask your network administrator to disable
the banner page.

Printing

· In the Windows 2000 printer driver, the settings
"Automatically Select" and "Auto Select" both appear as a
paper source. Select either one to allow the Fiery EX2101 to
select the paper source automatically.
·
The server will not allow multiple paper sources to be used
in a single print job. If the supply tray runs out of paper in
the middle of a print job, the server will require the user to
refill the tray before completing the job.
·
Job Notes (Notes 1 and Notes 2) may not be available when
you print from the PCL driver.
· If you cancel a job that requires an unavailable paper size,
the Fiery EX2101 Controller reboots. To avoid this problem,
make sure the copier has the necessary paper before you
print.
·
The default setting for the point and print driver is PS. To
change the default to PCL, on the LCD menu, select Run
Setup>Network Setup>Service Setup and then select PCL.
·
If you attempt to install a PnP PCL5 driver on a Microsoft
Windows 2000 client before installing it on the server, the
Microsoft Windows NT PCL5 driver will be installed. To
ensure correct installation of the PnP PCL5 driver, install it
on the server side before installing it on the client.
·
Installing the PCL printer driver on Microsoft Windows XP by
Point and Print is not supported. You can install the
Postscript printer driver on Microsoft Windows XP by Point
and Print.
·
Due to a system memory usage limitation, large print jobs
with Collate and Reserve options may pause before
completion.
Workaround: Cancel the current print job and change the
options to Collate and Forward.
· In order for an A4 MSWord document to print long edge feed
(LEF) via the Fiery PS driver, the document Paper Size must
be defined as A4 P. At the PS Print Driver, the Paper
Source Size must also be defined as A4 P.
Xerox 2101
GETTING STARTED