Original Type Selection And Output - Xerox DocuColor 12 User Manual

Original Type selection and output

When you use the Original Type options of Photo
& Text or Text, the copier/printer attempts to
discriminate between text and photo or picture
areas within the original. It then applies the
appropriate image processing to each area. Text
is reproduced at 600 lines per inch while photos
are reproduced at 200 lines or dots per inch.
Occasionally, a defect may occur where an area is
classified incorrectly and text is treated as photo
or vice versa.
To avoid this type of image quality defect for a
given original, select the Original Type options of
either Photo or Graphics and Maps. In these
modes, uniform image processing is applied to the
entire page.
NOTE: The resulting output may have a different
appearance in these modes. Some color
adjustments may be required.
If your original documents consist mostly of text or
mostly of photos, the System Administrator can
adjust the System Image Quality Image
Recognition settings. New default levels can be
set for Text & Photo Recognition and/or Text &
Photo Balance functions. The System
Administrator can select Text or Photo for Photo &
Text and Text modes.
Refer to the "Tools Mode, System Image Quality"
section in the System Administration Guide for
more information.
DOCUCOLOR 12 USER GUIDE 13–25
1
3
4
5
13
6
7
PROBLEM SOLVING