Mounting Subbase - Honeywell TRADELINE Q7300L Installation Instructions Manual
Series 2000 commercial thermostat subbases
Hide thumbs
Also See for TRADELINE Q7300L:
- Product data (36 pages) ,
- Product data (40 pages) ,
- Product data (40 pages)
Advertisement
SUBBASE
T
T7047C
T
T
T7047C
T
T
Fig. 3. Two T7047C Sensors and one T7047G Sensor
providing temperature averaging network for T7300/
Q7300 Thermostat/Subbase.
SUBBASE
T
T7047C
T
T
T7047C
T
T
Fig. 4. Four T7047C Sensors providing
temperature averaging network for
T7300/Q7300 Thermostat/Subbase.
SUBBASE
T
T
T7047G
T7047G
T
T
T7047G
T7047G
T
T
Fig. 5. Five T7047G Sensors providing
temperature averaging network for
T7300/Q7300 Thermostat/Subbase.
Q7300L SERIES 2000 COMMERCIAL THERMOSTAT SUBBASE
T
T7047G
T
T
M4839
T
T7047C
T
T
T7047C
T
T
M4840
T
T
T7047G
T
T
T
M4841
T7047C
T7047C
T7047C
Fig. 6. Nine T7047C Sensors providing
temperature averaging network for
T7300/Q7300 Thermostat/Subbase.
Mounting Subbase
The subbase mounts horizontally on the wall or a 2 in. x 4 in.
wiring box. Position the subbase horizontally on the wall or
on a 2 in. x 4 in. wiring box.
1. Position and level the subbase or wallplate (for
appearance only). The thermostat functions properly
even when not level.
2. Use a pencil to mark the mounting holes. See Fig. 7.
3. Remove the subbase or wallplate from the wall and
drill two 3/16 inch holes in the wall (if drywall) as
marked. For firmer material such as plaster or wood,
drill two 7/32 inch holes. Gently tap anchors (pro-
vided) into the drilled holes until flush with the wall.
4. Position the subbase over the holes, pulling wires
through the wiring opening.
5. Loosely insert the mounting screws into the holes.
6. Tighten mounting screws.
WALL
ANCHORS
(2)
T
3
SUBBASE
T
T
T7047C
T
T
T
T
T7047C
T
T
T
T
T7047C
T
T
T
T
WIRES
THROUGH WALL
LEDS
Fig. 7. Mounting the subbase.
T7047C
T
T
T7047C
T
T
T7047C
T
T
M4842
WALL
MOUNTING
HOLES
MOUNTING
SCREWS
M10237
62-0131—2
Advertisement
