Technical Specification - Mitsubishi Electric DPSClick User Manual

DPSClick User Manual

2. TECHNICAL SPECIFICATION

2.1 – Scanner
2.1.1 – Approved and Tested Scanners
The system is only guaranteed to work with scanners approved and tested by the
manufacturer, and which operate by FIRE WIRE
TWAIN communication protocol.
The basic difference between the Approved and the Tested Scanners is that the former
can work in Basic Mode and the latter only in Advanced Mode.
Section 4.7.1. of the manual describes these two working modes in greater detail.
For a detailed description of approved and tested scanners please see your dealer.
2.1.2 – Film Scanner for Index Print.
The system supports the use of any film scanner with TWAIN interface, although for
greater certainty some Scanner models have been approved. Please see your dealer.
The system works better with a Film Scanner that can preview the whole film strip. It's
necessary to make Index Print.
2.1.3 – Flatbed scanner
The system supports the use of any flatbed scanner with TWAIN interface, although for
greater certainty some Scanner models have been approved. Please see your dealer.
2.1.3.1 – Others
To use any scanner not on the list of approved models, install the Drivers supplied by
the manufacturer. Any such installation and its compatibility with the rest of the equipment
is the SOLE RESPONSIBILITY OF THE OWNER of the equipment. The manufacturer is
not responsible for correct installation and operation. Therefore, any cost derived from
handling the equipment will be met by the owner.
8
WARNING:
THE MANUFACTURER CANNOT BE HELD
RESPONSIBLE FOR THE OPERATION OF THE EQUIPMENT
IN THE CASE OF A SCANNER INSTALLED THAT IS NOT IN
THE LIST OF APPROVED OR TESTED SCANNERS.
TM
connection (IEEE 1394) or USB, and
v. 4.0