Advanced Option - Mitsubishi Electric MDT70IS User Manual

OSD screen functions (continued)

ADVANCED OPTION


INPUT RESOLUTION
* For the D-SUB inputs only.
If the monitor fails to recognize the input signal resolution
correctly, you can select a proper resolution manually.
Only when a signal having a resolution close to any of the
following values from three groups, the values in the most
appropriate group are selectable.
Group 1: AUTO, 1024 x 768, 1280 x 768, 1360 x 768, 1366 x 768
Group 2: AUTO, 1400 x 1050, 1680 x 1050
Group 3: AUTO, 1600 x 1200, 1920 x 1200

BLACK LEVEL EXPANSION
* For the HDMI1-HD, HDMI2-HD, DVI-D-HD, DISPLAYPORT
(YCbCr signal), OPTION (YCbCr signal), YPbPr, S-VIDEO,
and VIDEO inputs only.
Select the level of black expansion from OFF, MIDDLE, and
HIGH.

INPUT CHANGE
You can select the time for input switching from QUICK and
NORMAL.
NOTE: When you select QUICK, slight noise may appear.

INPUT DETECT
This function detects whether the video signals are present
or not at the video inputs and automatically select them.
The priority applies when more than one signal is input at
the same time. The signal being displayed isn't changed
even when a signal with higher priority is input.
AUTO SELECT
The target video inputs are DVI-D and D-SUB. When the
currently selected input signal is lost, this function checks
whether the signal is present at the other input. When
present, the other input is automatically selected.
If no signal is present at both inputs for fi ve seconds, the
monitor enters the sleep mode.
When an expansion module such as the SDI BOX is in the
option slot, OPTION is targeted instead of DVI-D.
The priority of the input signal is as follows:
DVI-D > D-SUB
NOTE: You cannot select other inputs than DVI-D,
OPTION, and D-SUB.
When an expansion module is mounted, the
monitor doesn't enter the sleep mode.
VIDEO DETECT
The target video inputs are HDMI1, YPbPr, S-VIDEO,
VIDEO, and D-SUB.
When the HDMI1, YPbPr, S-VIDEO, or VIDEO input is
detected, the detected input is automatically selected.
When the video signal being displayed is lost, the D-SUB
input is automatically selected.
The priority of the input signal is as follows:
HDMI1 > YPbPr > VIDEO > S-VIDEO
NOTE: You cannot select HDMI2, DVI-D, OPTION, and
DISPLAYPORT.
When an expansion module is mounted, the
monitor doesn't enter the sleep mode.
OFF
The video input isn't selected automatically.

SCAN MODE
* This function doesn't work when the D-SUB video input
is selected.
You can select the image display area.
OVERSCAN: About 95% of the input image is displayed.
UNDERSCAN: Almost 100% of the input image is
displayed.

SCAN CONVERSION
* This function doesn't work when the D-SUB video input
is selected.
It works on interlace signals only.
You can select the IP conversion mode.
PROGRESSIVE: Interlace signals are converted into
progressive signals. Select this setting for
normal cases.
INTERLACE: Interlace signals are displayed without
being converted. Though this setting is
suitable for motion images, still images
aren't displayed properly.

FILM MODE
* This function doesn't work when the D-SUB video input
is selected.
It works on interlace signals only.
You can select the fi lm mode function.
AUTO: Images of 24 frames per second are detected,
subjected to interpolation, and then displayed.
OFF: The input video signals are displayed without being
subjected to any processing.
NOTE: When FILM MODE is AUTO, set SCAN
CONVERSION to PROGRESSIVE. See page 55.
English-55