Mitsubishi Electric LAN Control Utility User Manual page 12

4. Projector registration
Procedure B - Connection examples 5 and 6 (where projectors are installed via a router)
To automatically detect projectors connected via a router, confirm the IP address in the projector network menu
and specify a range of IP addresses to search that particular IP address using "Search Projector Setting".
<Note>
If you want to connect a projector via a router after automatically detecting it, you need to specify a search range
of IP addresses that includes the projector's IP address in advance.
(1) Start up "ProjectorView Global+".
(2) Select "Search Projector Setting" from "Configuration" of the menu bar.
• "Search Projector Setting" window is displayed.
Item
 Start IP Address
 End IP Address
 Search Projector
(3) Specify the projector search range by IP address ( and ).
• Up to 16 search ranges can be set. (Settings can be configured for each line of the search range.)
(4) To save the settings, click [Save]. To continue the projector search, click [Search Projector].
• When you click [Save], the search ranges you specify are saved and the "Search Projector Setting" window
is closed.
• When you don't want to save the search ranges, click [Cancel] to close the "Search Projector Setting"
window.
• After saving the settings, by selecting "Configuration" on the menu bar and then selecting "Search
Projector", you can perform automatic projector search within the search ranges you saved.
• Some projectors may require you to enter the password when establishing projector connections for the
first time. Authentication is automatically performed from the second time onwards unless projectors are
deleted from the list.


Description
Specify the IP address that is the start of the search range.
(You cannot specify an IP address that contains a range other than 1 to 254 for
the first and last octets and a range other than 0 to 255 for the second and third
octets.)
Specify the last octet of the IP address that is the end of the search range. (You
cannot specify a value that contains a number other than 1 to 254. In addition,
you cannot specify a value that is smaller than the last octet of the search start IP
address specified in step .)
The settings you made are saved and then the automatic projector search is
performed.
EN-12
