Adjusting projected images (continued)
Adjusting the color variations
You can adjust the variations in the colors of the
images displayed on multiple projectors using the
menu settings.
(See page 31 for menu setting.)
Adjustment while viewing the screen
1. Display the MULTI-SCREEN menu.
2. Select COLOR MATCHING by pressing the or
button.
COLOR MATCHING
3. Select MANUAL by pressing the or button.
4. Select MANUAL by pressing the or button.
MANUAL
5. Select SETTING
by pressing the or button.
6. Press the ENTER button.
MANUAL – SETTING
COLOR
GAIN
SATURATION
HUE
WHITE R
WHITE G
WHITE B
AUTO PATTERN
7. Select an item you want to set by pressing the or
button.
• Select the color you want to adjust using
COLOR.
• When you set AUTO PATTERN to ON, the test
pattern of each color is displayed.
8. Select a setting value by pressing the or
button.
Repeat steps 7 to 8, if necessary.
Adjustment using a chroma meter
1. Display the MULTI-SCREEN menu.
2. Select COLOR MATCHING by pressing the or
button.
COLOR MATCHING
3. Select MEASURE by pressing the or button.
Set the measured brightness and the chromaticity
coordinates:
4. Select MEASURE by pressing the or button.
MEASURE
5. Select MEASURED DATA
button.
6. Press the ENTER button.
MEASURE – MEASURED DATA
COLOR
Y (RELATIVE)
x
y
OFF
SETTING
RED
100
0
0
- - -
- - -
- - -
ON
OFF
MEASURED DATA
by pressing the or
RED
*****
.
*
***
.
*
***
7. Select an item you want to set by pressing the or
button.
• Select the color you want to adjust using
COLOR.
8. Select a setting value by pressing the or
button.
• You can enter numbers by pressing the number
buttons (0 to 9) while holding down the NUM
button on the remote control.
Repeat steps 7 to 8, if necessary.
Important:
• The color tone may not be displayed correctly
depending on the setting value. Set the value within
the proper range.
Set the target values of the brightness and
chromaticity coordinates:
4. Select MEASURE by pressing the or button.
MEASURE
5. Select TARGET DATA
button.
6. Press the ENTER button.
MEASURE – TARGET DATA
COLOR
GAIN
x
y
AUTO PATTERN
7. Select an item you want to set by pressing the or
button.
• Select the color you want to adjust using
COLOR.
• When you set AUTO PATTERN to ON, the test
pattern of each color is displayed.
8. Select a setting value by pressing the or
button.
• You can enter numbers by pressing the number
buttons (0 to 9) while holding down the NUM
button on the remote control.
Repeat steps 7 to 8, if necessary.
Important:
The color tone may not be displayed correctly
•
depending on the setting value. Set the value within
the proper range.
Resetting the settings
• You can reset the SETTING, MANUAL, and
MEASURE settings to the factory defaults.
1. Display the MULTI-SCREEN menu.
2. Select SETTING, MANUAL or MEASURE by
pressing the or button.
3. Select RESET
4. Press the ENTER button.
EN-50
MEASURED DATA
by pressing the or
RED
.
*
***
.
*
***
.
*
***
ON
by pressing the or button.