How To Use Network Function - Mitsubishi Electric DLP XD700U User Manual

Network settings (continued)
• The number of characters of KEY varies
depending on the Encryption setting.
• WEP 128bit(ASCII): 13 chars
• WEP 64bit(ASCII): 5 chars
• WEP 128bit(HEX): 26 digits
• WEP 64bit(HEX):
• WPA-PSK(ASCII): 8-63 chars
• WPA2-PSK(ASCII): 8-63 chars
• WPA-PSK(HEX):
• WPA2-PSK(HEX): 64 digits
• If the entered content is outside character
number range, the KEY screen appears again
after an error dialog is displayed.
Wireless Setup setting
1. Display the Wireless Setting menu.
2. Press the  or  button to select Wireless Setup.
Wireless Setup
3. Press the ENTER button.
• Confirmation dialog appears.
4. If the ENTER button is pressed again, the Wireless
Setting will be reflected.
• It may take some time to reflect the setting.
Enabling or disabling the AMX
Device Discovery
Select this setting when using the AMX controller.
(See page 22 for menu setting.)
1. Display the Network Config menu.
2. Press the  or  button to select AMX Device
Discovery.
AMX Device Discovery
3. Press the ENTER button.
• AMX dialog appears.
AMX :
OK : ENTER
4. Press the  or  button to select ON
5. Select the item to set, and press the ENTER button.
• To cancel the setting, press the MENU button.
• It may take some time to reflect the setting.
Initialization of network settings
(See page 22 for menu setting.)
1. Display the Network Config menu.
2. Press the  or  button to select Network
Initialization.
Network Initialization
3. Press the ENTER button.
• Network Initialization dialog appears.
4. If the ENTER button is pressed again, the network
settings will be initialized.
• It may take some time to initialize the settings.
10 digits
64 digits
OK
Off
OFF
CANCEL : MENU
or OFF .
OK
Restart of network function
(See page 22 for menu setting.)
1. Display the Network Config menu.
2. Press the  or  button to select Network Restart.
Network Restart
3. Press the ENTER button.
• Network Restart dialog appears.
4. If the ENTER button is pressed again, the network
function will be restarted.
• It may take some time to restart the function.

How to use network function

• When connecting a computer and projector with
LAN, configure the both IP Addresses in the
same network group.
If connecting in different network group, be sure
to use a router. As for the settings of a router, ask
the network administrator.
• Configure the IP Config correctly. If the settings
are not correct, the communication may be
unavailable. For the detail, consult the network
administrator.
• Depending on the settings of Standby Mode of
the projector, LAN function may be unavailable.
See page 27 for the detail of Standby Mode.
Glossary
For more detail of the glossary below, refer to the
technical book that is commercially available.
Term
DHCP
IP Address
Subnet Mask
Default Gateway
MAC Address
EN-38
OK
Description
Abbreviation for Dynamic Host
Configuration Protocol. This
protocol automatically assigns IP
Address to networked devices.
Numerical address to identify
networked computers.
A numeric value to define the
number of bits used for a network
address of a divided network (or
subnet) in an IP Address.
A server (or router) to communicate
across networks (subnets) that are
divided by Subnet Mask.
Abbreviation for Media Access
Control Address. MAC Address is a
unique ID number assigned to each
network adapter. And this is based
on which data are sent and received
between network adapters.