Automatic Cleaning Filter - Mitsubishi Electric DLP WD8700U User Manual

Automatic cleaning filter

This projector is equipped with an automatic cleaning
filter. The burdensome filter cleaning is automatically
carried out.
• When the power of the projector is on, the filter is
cleaned after the designated time elapses.
• When the cumulative operation time since the
last cleaning of the automatic cleaning filter
exceeds the designated time, the filter is cleaned
automatically after you turn off the projector by
pressing the POWER button.
Important:
• When the cumulative operation time has exceeded
the designated time and you run the projector
continuously for 24 hours after turning on the
power, the automatic cleaning filter works while the
projector is operating.
Setting the cleaning interval
You can set the cleaning interval of the automatic
cleaning filter using the menu.
(See page 31 for menu setting.)
1. Display the INSTALLATION 2 menu.
2. Select FILTER MENU by pressing the  or 
button.
FILTER MENU
3. Press the ENTER button.
4. Select CLEANUP PERIOD by pressing the  or 
button.
CLEANUP PERIOD
5. Select 24H
or 1 WEEK
button.
24H
.............The filter is cleaned about every 24
hours.
1 WEEK .......The filter is cleaned about every 168
hours.
6. Press the ENTER button.
• When you select 24H
to set the cleaning interval is displayed.
24H
NEXT CLEANUP
2 4 H
0 1 2 3 4
OK
1 WEEK
NEXT CLEANUP
7 D 0 0 H
0 1 2 3 4
OK
ENTER
1 WEEK
by pressing the  or 
or 1 WEEK , the box
← →
DEL
5 6 7 8 9 CLEAR
CANCEL
← →
DEL
5 6 7 8 9 CLEAR
CANCEL
7. Move the key cursor using the direction buttons to
select the number you want to enter and then press
the ENTER button.
• Maximum interval
24H ........... 24H (about 24 hours)
1 WEEK
← key:
→ key:
DEL key:
CLEAR key: Deleting all the entered characters.
• You can enter the value by pressing the number
buttons (0 to 9) while holding down the NUM
button on the remote control.
• When the value you entered meets the following
conditions, an error dialog box is displayed at
the screen center for 3 seconds.
∙ The value has been cleared by DEL or CLEAR
and left blank.
∙ The value you entered is out of the setting
range.
24H
1 WEEK
∙ The value of each item is out of the setting
range.
D .................. 8 or over (1 WEEK
H .................. 25 or over
8. Select OK to accept the interval you entered and
exit the menu, or select CANCEL to exit the menu
without saving the setting.
• When you select OK or CANCEL, the CLEANUP
PERIOD menu is displayed.
EN-67
.... 7D 00H (about 168 hours)
S hifting the position of enter cursor
to the left for each character.
Shifting the position of enter cursor
to the right for each character.
Deleting the character in the
position of enter cursor for each
character.
......... 25H or over
... 7D 01H or over
only)