Advertisement
REMOVE
SHIPPINQ
MATERIAL
Remove all tape, shipplng and packaglng
materials and the oven rack packag-
Ing. Lift the cooktop
and remove the four shipping screws from the cooktop
burners.
These screws may be discarded.
LEVEL RANQE
?--
SHIPPING
, SCREW
For proper baklng results,
the range must be leveled. To do this:
1. Use a 1%" open end wrench or adjustable
wrench to equally back out the
four leg levelers two or three turns each.
2. Install
the oven racks In the oven (see your Use and Care Manual for
instructions).
3. Place the range where it will be installed,
then put a spirit level, or a lass
measuring
cup partially
filled with water, on one of the oven racks to c 7l eck
for levelness.
If using a s lrit
ed diagonally
first In one If
level, take two readlngs - with the level plac-
lrectlon, and then the other.
4. Use the wrench to adjust the leg levelers.
You may need to pull the range
away from the wall to reach the rear leg levelers.
ELECTRICAL
CONNECTIONS
Check wlth your power corn any for electrlcal
codes In your area. If there
are no local codes.
the Nat onal Electrlcal
Code. ANSI NFPA No. 70-1967
P
LEG
LEVELER
must be followed.
Ybu can get a copy by wrltlng:
'
Natlonal Fire Protection
Assoclatlon
Batterymarch
Park
Ouincy, MA 02269
An adequate
electrlcal
supply and outlet must be used to operate the elec-
trlcal parts of your range.
The range cord has a three prong plug and must be used wlth a my
grounded
three hole outlet with a standard
120 volt 60 hertz AC household
current.
Improper
grounding
un affect lgnltlon on apuk Ignltlon modds.
The preferred
method of electrical
hook-up
is shown In Fl
B
4. If you do not
have a grounded
(three hole) outlet, have a quallfled
electr clan change your
old outlet or Install a new one.
A grounding
adapter
plug may be used to convert
a two hole outlet
to a
three hole outlet
until a grounded
outlet can be Installed.
(See Flg. 5). Thls
should
be done only temporarlly
and only If the two hole outlet Is properly
polarized
and
9
rounded.
sum It meeta
Have a qualINed
elactrkkn
teat the outlet
to k
requIrementa.
3
CAUTION
Do not, under any
circumstances,
cut
or remove the groun-
ding prong from the
range cord. Failure
to
provide
proper
polarization
may
cause shock and fire
hazard.
Advertisement
