Channel Setting; Auto Channel Scan - Magnavox MDR533H Owner's Manual

Auto Channel Scan

If you have changed antenna connection, we recommend that you program available channels in your area with the
following procedures.

CHANNEL SETTING

Press [MENU] and use [K / L] to select
1
"General Setting", then press [OK].
"General Setting" menu will appear.
Use [K / L] to select "Channel", then
2
press [OK].
"Channel" menu will appear.
Use [K / L] to select "Auto Channel
3
Preset", then press [OK].
Use [K / L] to select the type of
4
broadcasting signal, then press [OK].
Auto Channel Preset
Antenna
Cable (Analog)
Cable (Analog / Digital)
The unit will start getting channels available in
your area.
• When using Antenna, Cable Box, or Satellite
Receiver with the RF Coaxial cable, you would
scan with the "Antenna".
• When connected to Cable TV, select "Cable
(Analog)" or "Cable (Analog / Digital)".
To cancel the auto channel preset during
scanning:
Press [RETURN] to go the previous screen or
[MENU] to cancel.
5
When scanning is over, press [MENU]
to exit.
To cycle through only the memorized channels, use
[CHANNEL / ].
To select a channel directly (including the ones not
memorized), use [the Number buttons] and [ • ] (for
digital TV channels).
Note
• If Auto Scan is cancelled during the scanning, some
channels will not be programmed.
EN EN 29