JS X Lock, JS+Y Lock, or JS-Y Lock, the tone that
was heard when the joystick is tilted can be main-
tained even after the joystick is returned to the
Similarly, there is an AfterT Lock function that
locks the aftertouch effect. ( PG p.220)
5 Press the [SW2] key once again to defeat the lock.
In many programs and combinations, the joystick -
Y axis lock function is assigned to the [SW2] key.
REALTIME CONTROLS , , ,
These knobs can be used to control the ﬁlter cutoff fre-
quency and resonance, the amp and ﬁlter EG, volume,
portamento time, pan, pitch LFO, or the send levels to
the master effects, etc.
1 Press the REALTIME CONTROLS [SELECT] key
to switch the function of the realtime controllers to
A-mode, B-mode, or C-mode.
Each time you press the key, A-mode, B-mode or C-
mode will be selected alternately, and the corre-
sponding LED will light.
2 Rotate the desired knob to control the sound, etc.
In A-mode, knobs – will control/edit the follow-
Placing the knobs in the center (12 o'clock) posi-
tion will produce the values speciﬁed by the pro-
Knob : LPF CUTOFF
Adjust the cutoff frequency of the low pass ﬁlter.
When you adjust the cutoff frequency of the ﬁlter, the
brightness of the sound will change. The effect will
depend on the settings of the program parameters, but
normally, rotating the knob toward the left will darken
the sound, and rotating it toward the right will
Knob : RESONANCE/HPF
Adjust the resonance level of a low pass ﬁlter or the
cutoff frequency of a high pass ﬁlter.
The content that is controlled will depend on the ﬁlter
type speciﬁed by the program.
By adjusting the ﬁlter resonance level, you can increase
or decrease the resonance level to add a unique charac-
ter to the sound.
Adjusting the cutoff frequency of the high-pass ﬁlter
will modify the thickness of the sound from which the
low frequency range has been ﬁltered out.
Knob : EG-INTENSITY
Adjust the ﬁlter EG intensity (the depth at which the
ﬁlter EG is applied).
Rotating the knob will affect the depth of the ﬁlter EG.
Normally, rotating the knob toward the left will make
the ﬁlter EG apply less deeply, and rotating it toward
the right will make the ﬁlter EG apply more deeply.
Since the ﬁlter EG will operate based on the cutoff fre-
quency of the ﬁlter, knobs  and  will work
together to control the tonal changes produced by the
Knob : EG-RELEASE
Adjust the EG release times of the ﬁlter and amp. This
will determine the time from note-off until the sound
When you adjust the knob, the release times of the ﬁl-
ter EG and the amp EG will change. Normally, rotating
the knob toward the left will shorten the release time,
and rotating it toward the right will lengthen the