Loading The Factory Settings - Roland Classic C-200 Owner's Manual

Loading the factory settings

If necessary, you can erase all settings you have saved inside the C-200 and instead load the settings the C-200 contained when
you first bought it.
The following procedure will erase all settings you have
made up to this point.
1.
While holding down the [Function] piston, press the
[Memory Piston].
The [Function] piston and [Memory Piston] start flash-
ing.
2.
Release the [Function] piston and [Memory Piston].
Be sure to proceed with step (3) within ±10 seconds. If
you wait longer, the [Function] piston and [Memory Pis-
ton] go dark. After that, you need to return to step (1) if
you still want to load the factory settings.
Additional Convenient Functionality <Advanced Operation>
3.
While holding down the lower part of the [SUBBASS
16] tilt tab, press the [Lute] piston.
The [Lute] piston starts flashing.
4.
Wait until the [Function] piston, [Memory Piston] and
[Lute] piston go dark.
5.
Switch off the C-200, wait a few seconds, then switch it
back on again to use the factory settings.
37