Tacking; Eyelet - Janome Sewing Machine Instruction Book

q w e
w
e
t
w e
q
q
r
r
q
w
e

Tacking

q Stitch pattern:
w Thread tension dial:
e Presser foot:
Tacking is used to reinforce pockets, crotches and belt
carriers where extra strength is needed.
• Start sewing
Start the machine and sew until the machine stops
automatically. The machine will sew a tacking 5/8˝
(1.5 cm) long.
q 5/8˝ (1.5 cm)
• Sewing a shorter tack
* Set the speed control slider at low speed setting.
To sew a tack shorter than 5/8˝ (1.5 cm), first stop the
machine after sewing the required length w, then press
the reverse stitch button e.
The tack length r has been determined.
Start the machine again and continue sewing until the
machine stops automatically.
w Required length
e Reverse stitch button
r Tack length
t Starting point
• Sewing a same-size darning
Simply start the machine to sew another tack at the
same size.

Eyelet

q Stitch pattern:
w Needle thread tension:
e Presser foot:
The eyelet is used for belt holes etc.
• Starting to sew
Attach the satin stitch foot F.
Start the machine. The machine will stop
automatically when completed.
Open the eyelet with an awl, eyelet punch or pointed
scissors.
• Adjusting the shape of an eyelet
Correct the shape of the eyelet as follows:
Press the cursor buttons
the value "L3" (default setting) q.
If the eylet gap opens w, press the
the darn even. (L1–L2)
If the eylet overlaps e, press
even. (L4–L5)
NOTE:
The shape can be adjusted within L1 to L5 (default
setting is L3).
31
28
3 to 6
Satin stitch foot F
29
1 to 4
Satin stitch foot F
to move the cursor under
button to make
button to make the darn