Part 3. Verify Correct Installation - HP Support Anywhere Installation And User Manual

Chapter 1
HP NetServer running Microsoft Windows NT:
complete installation for each NetServer running Windows NT.
¨
Step 1 Run HP Support Anywhere Server Setup
Insert the HP NetServer Navigator CD-ROM in your NetServer's CD-
ROM drive, and run setup.exe, located in the
HPSA\US\SERVER\DISK1\WINNT subdirectory. Choose "Install
SNMP Agents and WEB Interface Software".
¨
Step 2 Check SNMP Setup
Check SNMP setup to insure the correct listing of your client's community
name and address information. In the Windows Program Manager,
double-click Control Panel, then Network. Configure your SNMP Service
using the community name and address (as listed in the printout you
generated in Step 7 of Part 1). Enter IP and/or IPX addresses, and the
hostname if your network uses the DHCP protocol.
¨
Step 3 Restart the HP NetServer
To complete the installation, you must restart each HP NetServer that you
included in your Support Anywhere setup.

Part 3. Verify Correct Installation

Go to the client workstation to verify correct installation.
You will find that each restarted NetServer has sent a Server Restart message to
your designated client to let you know that installation was successful.
Depending on the number of NetServers installed, Auto Alert Server Restart
messages should already be queued up on the client display. However, they will
not be visible until you clear the Server Down messages that were automatically
posted before installation was completed.
1. Clear the Server Down notifications.
2. At each NetServer's Server Restart message, click Go There to test the
web connection.
3. Close the web browser displaying the NetServer's web page to return to
your local client's Auto Alert message.
4. Click OK to clear the Auto Alert message.
This reveals any previous Auto Alert notifications.
6
Quick Start
Follow these steps to