Functions - Haier HDY-D70 User Manual

Functions

F. Delay button
Touch this button before a programme starts. You may choose to start the
dryer after a preset time. The delay range is between 1 and 19 hours. Every
touch of the delay button will increase the delay by one hour. When you
pass 19 hours, the delay time will turn off. After a delay time is set, touch the
Start/Pause button to the start the delay operation and the indicator light
will flash.
G. programme progress display
Depending on the programme selected, the drying stage reached is shown
by the indicator lamps on the control panel:
Drying
Ready to iron
Airing
End/Anti-crease
At the end of a programme, the End/Anti-crease indicator lamp comes on.
The drum will continue to rotate at intervals to prevent laundry creasing, if
you do not choose to remove it immediately.
h. lED screen
This screen displays the remaining time for a programme, the delay time
and other related information.
The remaining time will vary during operation, due to varying factors e.g.
moisture content. The actual remaining time will be automatically adjusted
until the required result has been achieved and the programme is complete.
I. maintenance displays
Empty tank
Clean filter
Clean condenser
Important: After each drying cycle,
Clean the filter;
Drain the water collection box;
(See section "Cleaning and maintenance")
J. power button
When the machine is plugged in, press this button to switch on the dryer.
Press it again to switch it off.
D+E. Child lock function
During a programme, press and hold down both these buttons for 3
seconds at the same time to start the child lock function. The display screen
will then alternate between the remaining time and the lock, and the control
panel will be locked. Press and hold down both buttons for 3 seconds once
again and the child lock will disengage. The child lock will also disengage
if the programme is complete or if the power is switched off during the
programme.
10