Door Switch; Fan Cook/Cool Down Switch; Thermostat; Heat On Lamp - Garland S680 SERIES Installation And Service Manual

MAINTENANCE AND CLEANING continued

Miscellaneous

1 . Grease the door hinges and check for loose fasteners .
Tighten as necessary .
2 . Wire brush the surface of the griddle to remove baked
on material, wash with hot water, dry thoroughly . Lightly
coat the surface with vegetable oil to prevent rusting .

REPLACEMENT OF PARTS

Servicing must be carried out by competent persons in
accordance with the law .
WARNING: Turn off the electrical mains before commencing
any servicing work .

Door Switch

1 . Drop the lower kick panel .
2 . Remove the screws securing the door switch and
mounting brackets and remove screws securing the door
switch .
3 . Remove the terminal cover and disconnect the wires
from the terminals on the body of the switch .
4 . Replace the faulty door switch .
5 . Make certain that the newly installed door switch is
properly adjusted so as the interrupt the power supply
to the control system and fan motor when the door is
opened .

Fan Cook/Cool Down Switch

1 . Remove the screws securing the front panel to the front
rail and drop the panel .
2 . Disconnect the wires from the terminals on the switch .
3 . Depress the tabs of the switch body and push the switch
through the opening in the control panel .
Page 12
3 . Wipe exposed cleanable surfaces with a mild detergent
and hot water . Stubborn residue may be removed with
a light weight non-metallic scouring pad . Stainless steel
areas should be washed with a mild detergent, hot water
and a soft cloth . If necessary use a nonmetallic scouring
pad always rub in the of the grain in the metal to prevent
scratching . NEVER USE STEEL WOOL .
4 . Clean the oven racks shelves and guides with hot soapy
water and dry thoroughly . Clean the oven interior with a
propriety oven cleaner following instructions .
4 . Replace the switch and reassemble in reverse order .

Thermostat

1 . Remove the screws securing the front panel to the front
rail and drop the panel .
2 . Disconnect the wires from the taps on the thermostat .
3 . Remove the dial from the thermostat and the screws
securing the thermostat body to the control panel .
4 . Remove the wires from the thermostat terminals . Be sure
to note which wire connects to which terminal on the
thermostat .
5 . Remove the thermostat bulb .
6 . Replace the faulty thermostat and reassemble in reverse
order .

Heat On Lamp

1 . Remove the screws securing the front panel to the front
rail and drop the panel .
2 . Disconnect the supply wires to the lamp and remove the
faulty lamp .
3 Reassemble in the reverse order .
Part # P152 Rev 1 (01/13/10)