Graphics Port; Internal Ports And Connectors; Hard Disk Connection - Fujitsu D1837 Technical Manual

Internal ports and connectors

Graphics port

Technical data
Function:
Features:
Screen resolution
Depending on the operating system used, the screen resolutions in the following table refer to the
mainboard screen controller.
If you are using an external screen controller, you will find details of supported screen resolutions in
the operating manual or technical manual supplied with the controller.
Screen resolution
640 x 480
800 x 600
1024 x 768
1280 x 1024
1600 x 1200
1920 x 1440
2048 x 1536
Internal ports and connectors
The positions of the internal ports and connectors are shown on the Cover. Additional information on
some ports is also provided here.

Hard disk connection

An ultra ATA/66 or ultra ATA/100 hard disk must be connected with a cable especially designed for
the ultra ATA/66 or ultra ATA/100 mode.
► Connect the end of the cable marked with blue to the mainboard.
A serial ATA/150 hard disk must be connected with a serial ATA cable.
► Connect the cable to the hard disk and to the connector on the mainboard.
If you have connected one or two hard disks to a serial ATA (one hard disk is possible per serial
ATA connection), you must configure the respective settings in the BIOS Setup (further information
you can find in the BIOS Setup manual).
10 - English
2D/3D graphics controller, Dynamic Video memory Technology, 400 Mhz
integrated 24-bit RAMDAC
Display Data Channel (DDC), 2 DVO channels (up to 165 megapixels per
channel), dual-view support for ADD2 boards
Refresh rate (Hz)
120
120
120
120
120
85
75
Colour
32 bit
32 bit
32 bit
32 bit
32 bit
32 bit
32 bit
A26361-D1837-Z120-1-7419, Edition 1