Replacing The Charger - Troy-Bilt TB55B Operator's Manual

REPLACING THE CHARGER
Replace the charger if it is damaged, if the barrel
connector or cord become damaged, or if the barrel
connector is not contacting the unit properly.
CAUTION: Only use the type of charger
specified for this unit. Any other type may
cause damage to the unit, damage to the
batteries or possible injury.
Your trimmer requires a 12V charger (182534) and
charging station (180295). The charging instructions
refer only to these parts.
1. Unplug the charger from the wall outlet and remove
the unit from the charging station.
2. Remove the screw from the clamp holding the barrel
connector in place using a standard or T-20 Torx bit
screwdriver (Fig. 19).
3. Remove the barrel connector from the slot and
replace the charger, if needed.
4.
Insert the narrow side of the barrel connector wire
into the groove in the slot of the charging station.
Ensure that the barrel connector is inserted correctly
and secure (Fig. 19).
5. Reinstall the clamp and screw.
6. Plug the charger into the wall outlet. Refer to
Charging the Unit for charging instructions.
J Barrel Connector
Edge of Barrel
Connector Wire
Clamp
CLEANING
WARNING: To avoid serious personal injury,
always turn your trimmer off and remove the
battery before you c ean or serv ce t. J
WARNING: Battery tools do not have to be
plugged into an electrical outlet; therefore, I
they are always in operating condition. To
prevent serious personal injury, take extra
precaut ons and care when c ean ng the un t.
Switch off the unit and disconnect it from the power
source. Use a small brush to clean off the outside of the
unit. Do not use strong detergents. Household cleaners
that contain aromatic oils such as pine and lemon, and
solvents such as kerosene, can damage plastic housing
or handle. Wipe off any moisture with a soft cloth. Also
keep the air vents free of obstructions.
STORAGE
• Allow the unit to cool before storing.
• Lock the unit to prevent unauthorized use or damage.
• Store the unit in a dry, well-ventilated area.
• Store the unit out of the reach of children.
ACCESSORIES AND REPLACEMENT PARTS
Cutting Attachment Shield ................. 180293
Replacement Line ....................... 610375
Replacement Line Cartridge ................ 180292
Inner Reel Spring ........................ 180374
Bump Head Cover ....................... 180376
Charger ................................ 182534
Charging Station ......................... 180295
12 Volt Battery Pack ...................... 182391
Charging
_ Charger
Fig. 19
14