Battery Pack Replacement - Troy-Bilt TB55B Operator's Manual

BATTERY PACK REPLACEMENT
.,,_ To preserve natural resources, please recycle
\_,_f or dispose of properly. THIS PRODUCT
I CONTAINS A SEALED LEAD-ACID BATTERY
Pb AND MUST BE DISPOSED OF PROPERLY.
Local, State, Or federal laws may prohibit
disposal of sealed lead-acid batteries in
ordinary trash. Consult your local waste
authority for information regarding available
recycling and/or disposal options.
Removing the Battery
I. Push the two latches on the side of the battery housing
door in and swing the door down. Unhook the door
from the slot on the bottom of the battery housing by
lifting up and away. Set the door aside (Fig. 17).
Battery Housing
I_f/_he_Door
Hook
Fig. 17
2. Push down on the battery retaining latch while
pulling battery out (Fig. 18).
NOTE: You might notice grease on the terminal contacts
when the battery is removed. This is normal.
Battery
O Ret lining Latch
o
[ !
Fig. 18
WARNING: If the battery pack has signs of
leakage, do not touch. Do not open or
mutilate the battery. Released electrolyte is
corrosive and may cause damage to the eyes
or skin. To avoid serious injury, take the unit
to an authorized service dealer for repair.
Installing the Battery
1. Slide the battery into the battery housing until the
battery retaining latch locks the battery into place
(Fig 18).
2. Reinstall the door by hooking over the slot on the
bottom of the battery housing. Swing the battery
housing door closed until the two latches snap into
place.
For best performance when reinstalling the battery:
• Check the battery terminals for corrosion and clean
them if necessary. Clean the terminals using a dry
scrubbing pad and wipe clean with a dry cloth. Never
use liquids to clean terminals.
• Check the battery casing for signs of damage and
replace it if needed.
NOTE: If you clean or replace the battery, apply a small
amount of electrically conductive grease to the
terminals only. This grease is available at any
local electronics store. Do not use automotive or
beating grease.
Storing the Battery Pack
If you are removing the battery for replacement or for
storage, cover the battery pack's terminals with heavy
duty electrical tape.
WARNING: Do not attempt to destroy or
disassemble battery or remove any of its
components. Sealed lead-acid batteries must
be recycled or disposed of properly. Never
touch both terminals with metal objects
and/or body parts, a short circuit may result.
Keep away from children. Failure to comply
with these warnings could result in fire and/or
serious personal injury.
13