Glass Refractory, Base Pan, Burner And Valve Assembly Removal - Heat & Glo 6000CMOD-IPI Owner's Manual

C. Glass Refractory, Base Pan, Burner and
Valve Assembly Removal
It may become necessary to remove the glass panels,
base pan, burner and valve assembly. This task should
be performed by a qualifi ed service technician.
1. Remove the media.
2. Remove the side glass panel retainers. See Figure
3.2. Slide the side glass panels out of the appliance
as shown in Figure 3.3.
3. Remove the rear glass panel retainer, shown in Figure
3.2, and lift the rear glass panel out of the appliance.
REAR PANEL RETAINER
SIDE PANEL RETAINERS
Figure 3.2 Remove Glass Panel Retainers
Figure 3.3 Glass Panel Removal
16 Heat & Glo • 6000CMOD-IPI, 8000CMOD-IPI • 2241-900 Rev. i • 4/13
4. Remove the base pan by removing the screws circled
in Figure 3.4.
5. Remove the burner assembly by removing the two
screws as shown in Figure 3.5. To disengage the burner
from the orifi ce, slide the burner to the right and lift it out.
6. See Figure 3.6 for valve assembly removal.
APPEARANCE
MAY VARY
Figure 3.4 Base Pan Removal
Figure 3.5 Burner Assembly Removal