Making The Pc Image Brighter (Abl) - Pioneer PDP-502MXE Operating Instructions Manual

Making the PC image brighter
(ABL)
Set this mode to "ON" to brighten the image during PC
signal input. When ABL is set to "ON", the brightness of
the image will change according to changes in the input
signal. If you are bothered by changes to brightness
during operation, set this mode to "OFF".
I Press MENU to display the menu screen.
The menu screen appears.
2
Press •/v to select SET UP, then press SET.
MAIN MENU
PICTURE
SCREEN
ALL RESET
POWER SAVE
beET UP
MENU:MENU OFF
AV :SELECT SET:NEXT
4 Press SET to set the mode to "ON".
"ON" is set when this unit is shipped from the
factory.
SET UP
TERMINAL BNC
SETTING PC
SIGNAL RGB
CLAMP MODEl
"ABL ON
HENHANCE: 0
VENHANCE: 0
EXIT
AV:SELECT SET :CHANGE
Each time SET is pressed, the settings change in the
following order.
5 When the setup is finished, press MENU to exit
the menu screen.
Note
Make the setting for each input (INPUT3 or INPUT4).
3
Press •Iv to select ABL.
SET UP
TERMINAL : BNC
SETTING :PC
SIGNAL :RGB
CLAMP :MODE1
'ABL :OFF
HENHANCE: 0
VENHANCE: 0
EXiT
_V: SELECT SET:CHANGE
20
Erl