Connection To A Personal Computer - Pioneer PDP-502MXE Operating Instructions Manual

Connection to a personal computer
Connection method differs depending on the computer
type. When connecting, please thoroughly read the
computer's instruction manual.
Before making connections, be sure to make sure that
the personal computer's power and this unit's main
power is off.
For the PC input signals and screen sizes that this unit is
compatible with, please refer to Supplement 1 (page 26).
When connecting to INPUT4
%
Make separate SYNC connections for a component that
has RGB output separated into 5 output signals: green,
blue, red, horizontal synchronization signal, and vertical
synchronization signal.
When connecting to INPUT3
0@@@0
B _ H_ VD
When using INPUT3, set the impedance selector switch
to match the output impedance of the connected
component's synchronization signal.
When the output impedance of the component's
synchronization signal is above 75 £_, set this switch to
the 2.2 k_ position.
On-screen setup is necessary after connectioe.
Please see page 13.
Connect the cable corresponding to the shape of the
input terminal on this unit and the personal computer's
output terminal.
Secure by tightening the terminal screws on both units.
After connecting, on-screen setup is necessary.
Please see page 13.
Note
Depending on the type of computer model being connected, a
conversion connector or adapter etc. provided with the computer
or sold separately may be necessary.
For details, please read your PC's instruction manual or consult
the maker or nearest dealer of your computer
When connecting to INPUT4 (OUTPUT)
( .... )
4=
_--IIP_ To an external monitor
With this unit, it is possible to output the RGB signal to an
external monitor or other component from the INPUT4
OUTPUT terminal.
Note
An RGB signal will not be output from the INPUT4 OUTPUT
terminal when the main power of this unit is off or in standby
10
Erl