Assembly - Craftsman Incredi-Pull 316.240320 Operator's Manual

ASSEMBLING
T HE UNiT _-.'_
Begin by carefully unpacking the contents and making sure that
nothing is damaged.
INSTALLING AND ADJUSTING THE WHEEL ASSEMBLY
_ WARNING: To prevent serious personal injury, the wheelj
assembly must be installed when operating the unit.
WARNING: To avoid injury from the tines, wear heavy
gloves and a long sleeve shirt when installing the wheel
assembly.
Installing the Wheel Assembly
1. Set the unit on its side (Fig. 1).
2. Insert the wheel assembly into the wheel bracket (Fig. 1).
3. Insert the clevis pin through the wheel bracket and wheel
assembly and lock it in place with the cotter pin (Fig. 1).
NOTE: It may be necessary to adjust the position of the wheel
assembly before using the unit.
WARNING:
Before inspecting, cleaning, or servicing the
unit, stop the motor, wait for all moving parts to stop and
remove the battery. Failure to follow these instructions can
result in serious personal injury or property damage.
Adjusting the Wheel Assembly
1. Set the unit on its side (Fig. 1).
2. Remove the cotter pin and the clevis pin from the wheel bracket
and wheel assembly (Fig. 1).
3. Adjust the height by moving the wheel assembly along the wheel
bracket.
4. Insert the clevis pin through the wheel bracket and assembly and
lock it in place with the cotter pin (Fig. 1).
NOTE: Moving the wheel assembly down will raise the wheel height.
Moving the wheel assembly up will lower the wheel height.
POSiTiONiNG THE HANDLEBARS
installing the Wheel Assembly
1. Loosen the two knobs on the inside of the handlebars (Fig. 3).
2. With the unit upright, swing the handlebars up into the operating
position (Fig. 2).
NOTE: Take care not to pinch the throttle cable or switch wires
when positioning the handlebar (Fig. 3).
3. Tighten the knobs to secure the handlebars in place (Fig. 3).
NOTE: Do not over tighten the knobs.
4. Readjust the throttle cable and switch wires so they are smooth
and tight against the handlebar assembly. This will help prevent
them from catching or snagging during normal operation.
Cotter Pir_
Wheel
Bracket
Wheel
Assembb
Fig. 1
Fig. 2
Handlebar
Knobs
Throttle Cable
and Switch Wires
Handlebar Knobs
Fig. 3