Craftsman WEEDWACKER Incredi-Pull 316.795861 Operator's Manual page 5

APPLICATIONS
Asatrimmer:
• Cutting grass and light weeds
Edging
Decorative trimming around trees, fences, etc.
Asabrushcutter:
Cutting weeds and light brush ofup to1/2 inch indiameter
Other optional accessories may b eused w ith this unit.
Muffler
\ Spark Plug
Starter Rope
Shaft Grip Grip
On/Oft
Control Air Fiffer
D-Handle _ Cover
ShouNder
Strap Clip
C°nvertibleTM Throttle
CoupNer _ Control
Fuel Cap
Shaft Housing
Barrier Bar
Brush Blade
Blade Shield /
Shield Mount
Primer Bulb
HassNe Free ®
Cutting Head
Head Shield
Line Cutting Blade
INSTALL AND ADJUST THE D=HANDLE
1. Remove the screws and
bottom clamp piece that were
installed on the D-handle for
shipping.
2. Place the D-handle over the
shaft housing and onto the
bottom clamp (Fig. 1). Place
it a minimum of 6 inches
(15.24 cm) from the end of
the shaft grip.
3. Start the screws with a large
Flat-head or T-25 Torx
screwdriver. Do not tighten
until making the handle adjustment.
4.
5.
6.
NOTE:
Screw (4}
Minimum 6 in.
(15.24 cm)
Barrier Bar
/
Bottom
Clamp
Fig. 1
If it was pre-installed, loosen the screws on the D-handle just enough to
move it.
While holding the unit in the operating position (Fig. 17), move the D-handle
to the location that provides the best grip.
Tighten the clamp screws evenly until the D-handle is secure.
Make sure the barrier bar will point toward the operator's body
when the unit is held in the operating position.
OPERATING THE CONVERTIBLE
TM
COUPLER SYSTEM
WARNING:
Before using any attachment, read and understand
the manual that came with the attachment. Follow all safety I
nformat on conta ned w th n. j
The Convertible
TM
coupler system enables the use of these optional attachments.
Edger
Cultivator
Turbo Blower
Brushcutter
5
• Pole Saw
• Hedge Trimmer
INSTALLING THE TRIMMER ATTACHMENT OR OTHER ATTACHMENT
_[_ ARNING:
To avoid serious personal injury and damage to the
unit, shut the unit off before removing or installing attachments.
_L_J AUTION:
Before operating the unit, be sure that the release
button is fully snapped into the primary hole, and that the knob is
securely tightened.
NOTE: To make installing or Primary Hole
removing the attachmentj_.__.X, _, _----_¢-'-Y_
easier, place the unit on
the ground or on a work
bench.
Turn knob counterclockwise
_i__,_.. _
to loosen (Fig. 3).
While firmly holding the
attachment, push it straight Upper Shaft
into the Convertible
TM
Housing Lower Shaft
Housing
1.
2.
coupler until the release
button snaps firmly into the
primary hole (Fig. 2).
NOTE: Aligning the release
button with the guide
recess will help
installation (Fig. 4).
3. Turn the knob clockwise to
tighten (Fig. 3).
For decorative edging with the line
head trimmer attachment or other
attachment, lock the release
button of the attachment into the
90 ° hole (Fig. 3).
Fig. 2
90° Edging Hole
ly)
\
Knob
Fig. 3