Maintaining The Air Filter; Adjusting The Idle Speed; Starting A Nd Stopping; Cleaning Air Filter - Craftsman WEEDWACKER INCREDI.PULL 316.711370 Operator's Manual

2-cycle incredi-pull weedwacker gas trimmer
Hide thumbs Also See for WEEDWACKER INCREDI.PULL 316.711370:
Table of Contents

Advertisement

Available languages

Available languages

MAiNTAiNiNG THE AiR FILTER
WARNING:
To
avoid serious personal injury, always stop |
the engine and allow it to cool before cleaning or maintaining
J
the unit.
Failure to maintain the air filter can result in poor performance or can
cause permanent damage to the engine. Engine failure due to
improper air filter maintenance is not covered by the product warranty.
Cleaning
the Air Filter
1. Open the air filter cover: press in the lock tab and swing the air
filter cover to the right (Fig. 17).
2. Remove the air filter from inside the air filter cover (Fig. 17).
3. Wash the air filter in detergent and water. Rinse the air filter
thoroughly
and allow it to dry.
4. Lightly coat the air filter with clean SAE 30 oil.
5. Squeeze the air filter to spread and remove excess oil.
6. Reinstall the air filter inside the air filter cover (Fig. 17).
NOTE: Operating the unit without the air filter and air filter cover will
VOID the warranty.
7. Close the air filter cover: swing the air filter cover to the left and
press it closed until the lock tab snaps into place (Fig. 17).
Lock Tab
Fig. 17
Air Filter
\
Air Filter Cover
ADJUSTING THE iDLE SPEED
WARNING:
The cutting head may spin during idle speed[
adjustments.
Wear protective clothing and observe all
safety nstruct ons to prevent serous persona
njury,
j
NOTE: Careless adjustments can seriously damage the unit. A Sears or
other qualified service dealer should make carburetor adjustments.
if, after checking the fuel and cleaning the air filter, the engine still
will not idle, adjust the idle speed screw as follows:
1. Start the engine. Refer to Starting and Stopping.
2. Release the throttle control and let the engine idle. if the engine
stops, use a small Phillips screwdriver to turn the idle speed screw
clockwise, 1/8 of a turn at a time (as needed) until the engine idles
smoothly (Fig. 18).
3. if the engine is idling too quickly, turn the idle speed screw
counterclockwise,
1/8 of a turn at a time (as needed) to reduce the
idle speed (Fig. 18).
Checking the fuel, cleaning the air filter, and adjusting the idle speed
should solve most engine problems, if not, and any of the following
conditions are true, take the unit to a Sears or other qualified service
dealer:
the engine will not idle
the engine hesitates or stalls on acceleration
there is a loss of engine power
Fig. 18
[die Speed Screw
13

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents