Sears LXI series 934.55156690 Owner's Manual page 11

Table of Contents

Advertisement

If your TV does not have A/V terminals;
When the VCR is in the Playback
mode or when the
TV/VCR
button is in the VCR position, your TV will re-
ceive the signals from the VCR on either channel 3 or 4.
To use the VCR with your TV, set the selector
switch to
CH3 or CH4,
whichever
is not used or least used for
normal broadcasts
in your area. Then set your TV to that
same channel.
When you copy a video tape, or watch a prograln
re-
corded
on an another
source,
use audio/video
input
jacks.
NOTE:
You can use the audio and video input jacks on
the front panel of VCR instead
of using jacks
on the
back.
TO an audio
adaptercord
_0
R_]
l
I_
(not supplied)
VlDE_
|
L- _1
To an video output J ack
• When you connect the monaural
VCR (another
source) to this VCR, connect the Audio output jack
of the monaural VCR (another source) to the AUDIO
IN L jack of this VCR. The audio signal will be re-
corded in both L and R channel equally.
INPUT
SELECT
To use the external
input jacks, select the "LI" or "L2"
position.
• If you use the audio and video input jacks
on the
back of the unit, press 0, 0, 1 on the remote
control
to select the "LI" position.
• If you use the audio and video input jacks
on the
front
of the unit, press 0, 0, 2 on the remote control
to select the "L2" position.
You can select
"LI",
"L2" as a channel
by using the
CHANNEL
"A" or "V" button.
Note: "LI" and "L2" are found before the lowest memo-
rized channel.
(Example:
CH2)
If your TV has A/V input jacks, you may connect
your
VCR's
AUDIO/VIDEO
OUTPUT
jacks
to
the
audio/video
input jacks on back of your TV.
Direct audio/video
connections
usually result in a better
picture
and sound quality for tape playback.
Please see
yourTV's
owner's
manual for A/V input connections.
[Back oftheVCR]
Au::lioNideo
__
adaptercord
n_'-n=oI;ULDIOI@M_
1) Open the battery compartment cover by pressing the
cover on the remote unit in the direction of the arrow.
2) Insert 2 "AA" penlight batteries into the battery com-
partment in the direction indicated by the polarity
(+/-) markings.
3) Replace the cover.
Note to CATV system installer
This reminder
is provided
to call the CATV system
installer's
attention to Article 820-40 of the NEC that
provides
guidelines
for proper grounding
and, in par-
ticular, specifies
that the cable ground shall be con-
nected to the grounding
system
of the building,
as
close to the point of cable entry as practical.
EN
-11-
6A12

Advertisement

Table of Contents
loading

Table of Contents