Hotpoint 18 Owner's Manual And Installation Instructions page 21

Installation instructions
[] TRANSFER BOTTOM HINGE
BRACKET TO THE LEFT
For models with a base grille, remo_e it by ,grasI)ing, it
about 6" fron_ each end and pulling its botton_ edge
toward rot i.
Using a Torx <':drive_; move tile bottom hinge bracket
and plastic washer fl'om the right side to the left side.
NOTE: If the washer is not on the hinge bracket,
check to see if it is stuck to tile bottom of tile doo_:
@_i PlasticWasher
Hinge
For models with a base grille, before rei)laciw*_ tile
base grille, remove tile grille cap by removing tile
screw. Screw the cap to the opposite side.
Replace tile base g_ille by inserting tile tops of tile
metal clips into tile ox_d vents, making sure one of tile
plastic tal> on tile back of tile g_ille goes into each of
the oven vents. Then push tile bottom of tile g_ille
forward until it snaps into place.
[] TRANSFER CENTER HINGE
BRACKET TO THE LEFT
Remove tile center hinge bracket b v removing tile
three Torx _':screws.
NOTE: Kee I) these screws with tile hinge bracket.
They are long screws and will be used when installing
the hinge on the other side.
On some models, you will need to relnove tile col()>
matched caps fl'om tile screw heads beli)re you can
remove tile scre_vs. Use tile edge of a thin fiat blade to
gently I)_y the caps offthe screw heads. (A put_i knife
works well for this.) Cover tile blade with tape to
prevent scratching tile paint.
Remove the three Torx <'_ screws from the center left
side of the cabinet. Screw them into the holes on
the right side.
Place the center hinge bracket over the holes at
the center left side of the cabinet. Insert and
tighten the three long screws.
Replace the caps by snapping them over tile screws
with your finger.
ScrewCap
[] TRANSFER DOOR STOPS
On each doo_; moxe tile metal door stop trom tile
_ight to tile left.
Moxe any scrm_s from the left to the right.
DoorSto
LeftSide
RightSide
21