Advertisement
Available languages
Available languages
Loading and using the drger.
Alwags follow the fabric manufacturer's care label when laundering.
Sorting and Loading Hints
As a general rule, if clothes are sorted properly for the
washer, they are sorted properly for the dryer.
Do not add fabric softener sheets once the load has
become warm. They may cause fabric softener stains.
Bounce®Fabric Conditioner Dryer Sheets have been
approved for use in all GE Dryerswhen used in
accordance with the manufacturer's instructions.
Do not overload. This wastes energy and causes
wrinkling.
Do not drg the following items:fiberglass items,
woolens, rubber-coated items, plastics, items with
plastic trim and foam-filled items.
Careand Cleaning of the Orger
The Exterior'. W ipe or dust any spills or washing
compounds with a damp cloth. Dryer control
panel and finishes may be damaged by some laundry
pretreatment soil and stain remover products. Apply
these products away from the dryer. The fabric may
then be washed and dried normally. Damage to your
dryer caused by these products is not covered by
your warranty.
The Lint Filten Cleanthe lint filter before each
use. Moistenyour fingers and reach into the filter
opening. Runyour fingers acrossthe filter. Havea
qualifiedtechnician vacuum the lint from the dryer
once a year.
/
Stainless Steel: To clean stainless steel surfaces,
use a damp cloth with a mild, non-abrasive cleaner
suitable for stainless steel surfaces. Remove the
cleaner residue, and then dry with a clean cloth.
The Exhaust Duct: Inspect and clean the exhaust
ducting at least once a year to prevent clogging.
A partially clogged exhaust can lengthen the
drying time.
Follow these steps:
IT1 Turn off electrical supply by disconnecting the
plug from the wall socket.
I-_ Disconnect the duct from the dryer.
[-3-1 Vacuum the duct with the hose attachment and
reconnect the duct.
TheExhaust Hood: Checkfrom the outside that the
flaps of the hood move freely when operating. Hake
surethat there is not wildlife (birds,insects,etc.)nesting
insidethe duct or hood.
10
Advertisement
