GE JKP30 Owner's Manual page 29

GEAppliances.com
Possible Causes What To Do
"F-- and a number You have a function . Press the Clear/Off pad. Allow the oven to cool for
or letter" flash error code. one hour. Put the oven back into operation.
in the display ff the function . Disconnect all power to the oven for at least 30
code repeats, seconds and then reconnect power. If the function
error code repeats, call for service.
Display goes blank A fuse in your home may . Replace the fuse or reset the circuit breaker.
be blown or the circuit
breaker tripped.
The clock is in the . See the Special features ofyour oven control section.
black-out mode.
Display flashes Power failure. . Reset the clock.
Unable to get the
display to show SF"
Oven control pads were
not pressed properly.
. The Bake and Broil Hi/Lo pads must be pressed
at the same time and held for 3 seconds.
Power outage, Power outage or surge. . Reset the clock. If the oven was in use, you must reset
clock flashes it by pressing the Clear/Off pad, setting the clock
and resetting any cooking function.
"Burning" or "oily" This is normal in a . To speed the process, set a self-clean cycle for a
odor emitting from new oven and will minimum of 3 hours. See the Using the self-cleaning
the vent disappear in time. oven section.
Strong odor An odor from the insulation . This is temporary.
around the inside of the
oven is normal for the first
few times the oven is used.
Fan noise A cooling fan may , This is normal. The cooling fan will turn on
automatically turn on. to cool internal parts. It may run for up to 1-!/2
hours in 30" models and up to 2 hours in 27" models
after the oven is turned off.
29