Troubleshooting Tips - GE GSC3500D35WW Owner's Manual

Before you call for service...
Troubleshooting Tips Save time and money! Review the charts on the following
pages, or visit GEAppliances.com. You may not need to call for service.
Problem Possible Causes What To Do
Dishwasher wont run
Noise
Fuse is blown, or the • Replacefuse or reset circuit breaker. Remove any other appliances
circuit breaker tripped from the circuit.
• Try pressing the START/RESET p ad (Electronic models) two times.
Power is turned off • In some installations, power to the dishwasher is provided through a wall
switch, often located next to the disposer switch. Hake sure it is on.
Some of the sounds • Soft food disposal shredding action.
you'll hear ore normal • Drain valve opening to pump water out.
• Timer control as cycle progresses.
• Detergent cup opening.
• The motor stopping during the drying period.
• Water drainingout of tub immediatelyafter touching the START/RESET pad.
Utensils ore not secure • Hake sure everything is secured in dishwasher.
in rock or something small
has dropped into rack
Rattling dishes when • Hake sure dishes are properly loaded. See the Loading the
the spray arm rotates dishwasher rocks section.
Motor hums • Dishwasher has not been used on a regular basis. If you do not use
your dishwasher often, set it to fill and pump out once every week.
This will help keep the seal moist.
Water standing in This is normal • A small amount of clean water around the outlet on the tub bottom
the bottom of the tub at the back of the tub keeps the water seal lubricated.
Water won't pump Drain is clogged • Checkto see if your kitchen sink is draining well. If not, you may need
out of the tub a plumber.
• If the dishwasher drains into a disposer, run disposer clear.
Suds in the tub Wrong detergent • Use onlyautomatic dishwasher detergents to avoid sudsing.
was used Cascade®and Cascade®Complete Automatic Dishwashing
Detergents have been approved for use in all GE dishwashers.
• To remove suds from the tub, open the dishwasher and let suds
dissipate. Add i gallon of cold water to the tub. On Models with a Dial:
Close and latch the dishwasher. Pump out water by slowly turning the
Dial until a drain period is reached. Repeat if necessary.On Models with
ElectronicControl: Pump out water by pressing the START/RESET p ad,
then 10 seconds later, press START/RESETpad again. Repeat if necessary.
• Always wipe up rinse agent spills immediately.
• Use of the RINSEONLYcycle after adding the dish to the load
can decrease the level of staining. GErecommends Cascade®
Plastic Booster to help remove these types of stains.
• Removethe stain by hand, using a solution of 1/2 cup bleach
and 3 cups warm water.
WARNING
Before cleaning interior, wait at least 20 minutes after a cycle for the
heating elements to cool down. Failure to do so can result in burns.
Rinseagent was spilled
Stained tub interior Some tomato-based
foods can cause reddish
stains
Tea or coffee stains
14
An overall yellow or
brown film can be
caused by iron deposits
in water
ADVERTENCIA
Antesde limpiarel interior,esperepar Io menos20 minutosdespuesde un ciclo
para que loselementoscalentadoresseenfrJen. N ohacerlopuede provocar
quemadums.
• A special filter in the water supply line isthe only way to correct
this problem. Contact a water softener company.
White film on inside
surface-hard water
minerals
• GE recommends Cascade Crystal Clear_ to help prevent hard water
mineral deposits from forming.
• Rundishwasher with citric acid to remove mineral deposits. Citric
acid (Partnumber: WD]5X151) can be ordered through GE Parts.
See back cover for ordering information.