Automatic Icemaker - GE Profile 21 Owner's Manual And Installation

About the automatic icemaker. .. . EAmia.ce.co
A newly-installed refrigerator may take 12 to 24 hours to begin making ice.
Power switch
Automatic Icemaker
It is nomlat for several cubes to be joined
together.
The icemaker will produce seven cubes per
cycle-approximately 100-130 cubes in a
24-hour period, depending on freezer
compartment temperature, room
temperature, number of door openings
and other use conditions.
I£ the refrigerator is opei_ted before the ill I
_'m: i water connection is made m the icemaker,
set the power switch in the O(off)position .....
When the refrigerator has been connected
to the water supply, set the power switch to
the I (0n) position.
The icemaker will fill with water when it cools
to fi-ee_g. A newt_imtalled refrigerator may
take 12 to 24 hours to begin making ice
cubes.
Throw away the first few batches of ice to
allow the water line to clear.
Be sure nothing interferes with the sweep of
the feeler arm.
When the bin fills to the level of the feeler
arm, the icemaker will stop producing ice.
If ice is not used frequendy, old ice cubes
will become cloudy, taste stale and shrink.
There is an upper freezer sheff
above the icemaker that can be
used for storage.
If ice cubes get stuck in the icemaker, the
green power light will brink. To correct this,
set the power switch to 0 {otOand remove
the cubes. Set the power switch to I (on)to
restart the icemaker. After the icemaker has
been turned on again, there will be a delay
of about 45 minutes before the icemaker
resumes operation.
Ice Storage Drawer
To access ice, pull the drawer forward.
TOremove the drawer, pull it straight out and
lift it past the stop location.
13