Philips SRU 1010 Instructions For Use Manual: Setting The Remote Control

Philips universal remote control instructions for use.
Hide thumbs

Advertisement

Setting the remote control

This is only necessary if your TV does not respond to the SRU 1010. If that is the case, the SRU 1010 does
not recognize the brand and/or model of your TV and you need to program the remote control to do so.
The example below instructs you how to do this.You can set the remote control either manually or
automatically.
Manually setting the remote control
1
Turn on the TV manually or use the original remote control.Tune in to channel 1.
2
Look up the brand of your TV in the code list at the back of this manual.
One or more 5-figure key codes are shown for each brand.
Note the first code.
On our website www.philips.com/urc you can directly select your device
typenumber to find the right code.
Make sure you use the codes from the correct table.
3
Keep keys s and y on the SRU 1010 pressed simultaneously for
five seconds until the indicator light remains lit.
4
Then enter the code noted in step 2 using the code keys.
The indicator light will now flash twice. If the indicator light flashes once for
an extended period, the code has not been entered properly or the wrong
code has been entered. Start again from step 2.
5
Point the SRU 1010 at the TV and check that it responds as it should.
If the TV responds to all of the key commands, the SRU 1010 is ready for use.
Do not forget to note your code.
If the device does not respond at all, or not to all of the key commands, start again from
step 2 and try the next code from the list.
ENGLISH
5

Advertisement

   Related Manuals for Philips SRU 1010

This manual also for:

Sru1010/10

Comments to this Manuals

Symbols: 0
Latest comments: