Advertisement
About
storage
drawer
and cover
removal,
GEAppl ances.com
Not all features
are on all models.
Humidity
Contro!
HiGH
LOW
Adjustable
Humidity Drawer
(on
some models)
Slide the control all the way to the
Slide the control all the way to the LOW
HIGH setting to provide high humidity
setting to provide lower humidity levels
recommended
for most vegetables,
recommended
for most fruits,
Drawer and Cover Removal
Drawers can be removed easily by grasping the sides and lifting up slightly while pulling drawers
past the slop location.
Full=Width
Drawer
with
Plastic
Cover
To remove the cover, lift it off its supports,
pull it forward, tilt it and take it out,
Twin Drawer Shelf
To remove:
_] Remove the drawers,
[_-] Reach in, push the front of glass cover up,
and at the same time, pull it forward as
far as it will come.
Tilt it and take it out. Avoid cleaning the cold
glass cover with hot water because the extreme
temperature difference may cause it to break.
F_ Remove the drawer frame, (Always
remove the glass cover before you take
out the drawer frame,)
Lift the frame off the supports at each side and
back, pull it forward, tilt it and take it out,
To replace:
-_ ower the frame until it rests on the
supports at each side and back,
[2--]Replace the glass cover, pushing its rear
edge firmly into the rear frame channel
and gently lowering the front into place,
F_ Replace the drawers.
About the automatic icemaker.
A newly-installed
refrigerator
There are 2 types of icemakers:
Feeler A rm
PowerSwitch
Power switch model
i
theSTOP
FeelerArmin
up position
the ON (down)..........
position
Feeler arm model
may take 12 to 24 hours to begin making ice.
Automatic
Icemaker
(on some models)
The icemaker will produce approximately 70-100
cubes in a 24-hour period, depending on the
freezer compartment temperature, room
temperature, number of door openings and
other use conditions.
If the refrigerator is operated before the water
connection is made to the icemaker, set the
switch to OFF or move the feeler arm to the
STOP(up) position,
When the refrigerator
has been connected to
the water supply, set the switch to the ON
position or move the feeler arm to the ON
(down) position,
The icemaker will fill with water when it cools to
15°F,A newly-installed refrigerator may take 12 to
24 hours to begin making ice cubes,
Once the icemaker starts to make ice, it may
take up to 48 hours to fill the bin, depending
on the temperature
settings and number of
door openings,
You will hear a buzzing sound each time the
icemaker fills with water,
Throw away the first few batches of ice
to allow the water line to clear,
Be sure nothing interferes with the sweep of
the feeler arm.
When the bin fills to the level of the feeler arm,
the icemaker will stop producing ice.
It is normal for several cubes to be joined
together.
If ice is not used frequently, old ice cubes will
become cloudy, taste stale, shrink or fuse
together.
Icemaker Accessory Kit
If your refrigerator did not already come
equipped with an automatic icemaker, an
icemaker accessory kit is available at extra cost.
Check the back of the refrigerator for
the specific icemaker kit needed for
your model.
Advertisement
