Reversing The Door - GE Appliances DCCB330 Owner's Manual

Reversing the door.
Tools needed:
• Standard #2
Phillips screwdriver
• Tape-tipped
putts knife
rl] open the door and remove the filler plugs opposite the hinges. With the door
completely open, remove the bottom screw from each hinge on the dryer face.
Insert these screws (]bout halfway into the TOP holes, for each hinge, on the
opposite side (where you removed the filler plugs).
Apply firm pressure to get the screw started in new holes.
r2-] Loosen top screw from each hinge on the dryer face halfway. With one hand
holding the top of the door and the other hand holding the bottom, remove the
door from the dryer by lifting it UP and OUT.
\\
r-_ Rotate the door 180 °. Insert it on the opposite side of the opening by moving the
door IN and DOWN until the top hinge and the bottom hinge (]re resting on the
top screws inserted in step 1.
@ Remove the remaining screws from the side of the opening from which
the door was removed. With these screws, secure each hinge at the bottom.
Tighten the two top screws of each hinge. Reinsert the plastic plugs on
the side from which the door was removed.
6