Table of Contents
Advertisement
Assembly
The G0733 and its com-
ponents are very heavy.
Get lifting help or use
power lifting equipment
such as a forklift to move
heavy items.
To assemble your lathe:
1.
position the right and left stand legs upright
approximately 57
3
reasonably aligned (see figure 9).
57
⁄
"
3
4
figure 9. supporting legs.
2.
Carefully position the lathe onto the stands
and align the mounting holes.
3.
secure the lathe assembly to the stand legs
with (8) m8-1.25 x 35 cap screws and 8mm
lock washers, as shown in figure 10.
x 8
figure 10. securing lathe assembly.
-16-
⁄
" apart, and get them
4
4.
if bolting the lathe to the floor, skip to
Step 7. otherwise, move the tailstock, tool
rest assembly, and headstock to one end of
the lathe bed (refer to OpERATiONS section,
beginning on page 19, for instructions for
moving these components).
5.
use assistants to lift one end of the lathe
onto support blocks and stabilize the lathe
in preparation for installing the machine feet
(see figure 11).
figure 11. legs supported for feet installation.
6.
remove the top hex nut from the feet, then
insert the feet into the mounting holes of the
leg (see figure 12). do not tighten the hex
nuts yet. remove the supporting block and
repeat Steps 5–6 on the other leg.
figure 12. machine feet installed.
Model G0733 (Mfg. Since 10/11)
support Block
Advertisement
Table of Contents
