1100 Keyboard Bezel Assembly With Fingerprint Reader, Smart Card Reader, And Speaker Assembly - Lenovo ThinkPad T430s Hardware Maintenance Manual

When installing:
Attach the backup battery
firmly.
1100 Keyboard bezel assembly with fingerprint reader, smart card
reader, and speaker assembly
For access, remove these FRUs in order:
• "1010 Battery pack" on page 64
• "1030 Solid-state drive or hard disk drive" on page 66
• "1080 Keyboard" on page 79
Note: In models with the fingerprint reader, the fingerprint reader sensor is attached to the keyboard bezel
assembly. If the fingerprint reader is defective, you can replace the keyboard bezel assembly by following
the procedures in this section. The replacement procedures are the same for a keyboard bezel assembly
with or without a fingerprint reader.
Removal steps of keyboard bezel with fingerprint reader
Step Screw (quantity)
1
M2 × 5 mm, flat-head, nylon-coated (13)
2
M2 × 3 mm, flat-head, nylon-coated (1)
a
in the insulation sheet and make sure that the battery connector is attached
Color Torque
Black 0.181 Nm
(1.85 kgf-cm)
Silver 0.181 Nm
(1.85 kgf-cm)
.
Chapter 9 Removing or replacing a FRU
85