Connections - Kenwood C-414 Instruction Manual

Connections

Right speaker
iPod applied part
Video cord
To TV with video (composite)
input terminal
Connect the audio output of the VCR, etc.
to the [AUX IN] terminals on the rear of the
main unit.
Connect a subwoofer (SW-40HT (separately available),
etc.) to the [SUB WOOFER PRE OUT] terminal on the rear
of the main unit.
¤
CAUTION
The power in this equipment will not be completely cut off
from the wall outlet when the standby switch is turned off.
Install the equipment so that the wall outlet is easily
accessible and, in case of emergency, immediately unplug
the power plug from the wall outlet.
Mains plug is used as the disconnect device, It shall remain
readily operable and should not be obstructed during
intended use.
6
C-414
AM loop antenna
F M
7 5 Ω
FM indoor antenna
Left speaker
To AC wall outlet
• Insert the plug firmly all the way
into the AC wall outlet.
AC adapter Power cord
Use the AC adapter (AC- Two types of power cords
18335A) provided with this
are provided. Select the one
product. designed for the country in
which this unit is used.
¤
CAUTION
Be sure to adhere to the following, or proper
ventilation will be blocked causing damage or
fi re hazard (Main unit and AC adapter).
• Do not place a cloth on the system or place it on a carpet
or cushion.
• Do not use the system in a poorly ventilated place.
• Do not place any objects impairing heat radiation onto
the top of the unit.
• Leave some space around the unit (from the largest
outside dimension including projection) equal to or
greater than, shown below.
Top panel : 50 cm
Connecting the FM antenna
1 Connect the lead to the [FM 75Ω] terminal.
2 Find the location that gives the best
reception.
3 Secure the antenna as high up as possible.
• The antenna supplied with the system is a basic antenna
for indoor use. For stable signal reception, the use of an
outdoor antenna (commercially available) is recommended.
Disconnect the indoor antenna first before connecting an
outdoor antenna.
¤
CAUTION
• Since antenna installation necessitates skill and experience,
always consult your dealer before installation. The antenna
should be placed at a distance from the power distribution
wires. Otherwise, an electric shock accident may occur if the
antenna falls down.
Connecting the AM antenna
1 Connect the AM antenna cord to the [AM] and [HGND]
terminals.
2 Setup the antenna in the position and the direction to be
able to receive AM broadcast.
• The antenna supplied with the system is for indoor use. Place
it as far away as possible from the system, your TV set, the
speaker cords, AC adapter and the power cord, and point it in
the direction that provides the best reception.
Connecting the iPod applied part
F M
1 Connect the iPod applied part to iPod applied part
7 5 Ω
connector
2 Insert the Dock adapter into unit.
3 Connect your iPod/iPhone.
To remove Dock adapter
• Insert a thin object such as the tip of a flat-blade screwdriver
into the slit on the dock adapter and lift it to remove.
⁄
• Connect an iPod dock adapter, which is provided with your
iPod/iPhone or commercially available in iPod dealers, to
the iPod dock of this unit. Note that the iPod adapter is not
provided with this unit.
• See page 9 for the supported iPod/iPhone models.
7
English